E-07 SENYANG 森阳
Applies to: DTF / 热升华（森阳板） · Firmware: v1.6 - v2.2
What the customer sees
E-07 alarms during cleaning; the capping does not move. (Completely different meaning from E-07 on HOSON boards)
Most likely causes (ranked)
50% Capping motor stuck (dried-ink buildup)
25% Lift track dry, lacks lubrication
15% Limit switch failure
10% Driver circuit failure
4 steps the customer can do
1
Power off, visually check and clear dried-ink buildup around the capping.
2
Clean waste ink and paper debris around the capping.
3
Make sure the waste-ink tube is not kinked flat.
4
Power off 5 minutes, restart once, run cleaning again.
3 technician steps
1
Inspect the capping motor and gears.
2
Calibrate the limit-switch position.
3
Replace the capping assembly if needed.
3 customer prohibitions
Related parts: 墨栈总成 / 限位开关 / 墨栈电机
Start step-by-step diagnosis from this code →Contact an online technician (Human-Gate PENDING)← Error Codes
High-risk actions enter the Human-Gate queue and are never auto-executed.